close
close

Lenze Ac Tech Fault Codes. For download from the lenze website (www.lenze.com). Lenze ac tech corporation inverter products are sold with no warranty of fitness for a particular purpose or warranty of suitability for use with explosion proof motors.

Lenze Ac Tech Fault CodesLenze Ac Tech Fault Codes
Lenze Ac Tech Fault Codes from cts2.mayorsagenda.com

Sm010s scm series electronic programming module (epm) Lenze ac tech corporation cannot assume responsibility for any modifications not authorized by its engineering department. Lenze ac tech corporation inverter products are sold with no warranty of fitness for a particular purpose or warranty of suitability for use with explosion proof motors.

Lenze Ac Tech Corporation Inverter Products Are Sold With No Warranty Of Fitness For A Particular Purpose Or Warranty Of Suitability For Use With Explosion Proof Motors.

If an scf motor control, under normal use, becomes defective within the stated warranty Lenze ac tech smv variable frequency drive manual.pdf author: Although most issues that occur with the smv are setup issues, there can be faults that may occur during normal operation of the drive.

Lenze Smvector 13465100 Edbsv01 En V18 11.

Ambient temperature is too high. 1.3 warranty lenze ac tech corporation warrants the scf series ac motor control to be free of defects in material and workmanship for a period 24 months from date of shipment from lenze americas' factory. Sm010s scm series electronic programming module (epm)

Custom Fault Numbers Must Be In Region Of 128 To 240 (Decimal) Syntaxfault Sets System Fault.

Convection cooled f = nema 4x/ip65; Convection cooled d = nema 4x/ip65; An epm with a different parameter version has been installed.

For Download From The Lenze Website (Www.lenze.com).

The drive will enter an overload fault state when the drive current hits 150% of the output capacity for one minute. For 400.480 vac models, the output current maximum (%) in the 400v column is used when p107 = 0. Our servo inverters are the specialists for motion control of one or more servo axes.

Follow The National Electrical Code And All.

Capacitors retain charge for approximately 180 seconds after power is removed. Indoor only c = nema 4x/ip65; For 400.480 vac models, the output current maximum (%) in the 480v column is used when p107 = 1.

Comments to: Lenze Ac Tech Fault Codes

Your email address will not be published.